Tag Archives: toyota sequoia

Reset service light Toyota Sequoia first generation

Leave a reply

Reset VSC trac warning light Toyota Sequoia first generation. From year: 2005, 2006, 2007.

How to reset VSC trac warning light Toyota Sequoia 1 generation.

This light warns that there is a problem somewhere in the vehicle stability control system and traction control system (two−wheel drive models) or active traction control system (four−wheel drive models). The light will come on when the ignition key is turned to “ON” and will go off after a few seconds. If the light comes on while driving, the system does not work. However, as conventional braking operates when applied, there is no problem to continue your driving.

In the following cases, contact your Toyota dealer:

  • The warning light does not come on after the ignition key is turned to “ON”.
  • The warning light remains on after the ignition key is turned to “ON”.
  • The warning light comes on while driving.

    • All information how can you reset VSC trac warning light is taken from Toyota Sequoia owners manual.

    Reset service light Toyota Sequoia first generation

    Leave a reply

    Reset VSC trac warning light Toyota Sequoia first generation. From year: 2005, 2006, 2007.

    How to reset VSC trac warning light Toyota Sequoia 1 generation.

    This light warns that there is a problem somewhere in the vehicle stability control system and traction control system (two−wheel drive models) or active traction control system (four−wheel drive models). The light will come on when the ignition key is turned to “ON” and will go off after a few seconds. If the light comes on while driving, the system does not work. However, as conventional braking operates when applied, there is no problem to continue your driving.

    In the following cases, contact your Toyota dealer:

  • The warning light does not come on after the ignition key is turned to “ON”.
  • The warning light remains on after the ignition key is turned to “ON”.
  • The warning light comes on while driving.

    • All information how can you reset VSC trac warning light is taken from Toyota Sequoia owners manual.

    Service oil reset Toyota Sequoia

    Leave a reply

    How to reset oil service light Toyota Sequoia. From year: 2005-2008

    Turn the ignition to run (one position before starting engine).
    Ensure odometer reading is shown. Turn ignition off.
    While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
    Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
    Turn the ignition off and then start the engine to verify the indicator has been reset.

    2009-2010
    1.Turn the ignition to run (one position before starting engine).
    2.Ensure Trip Metre A reading is shown. Turn the ignition off.
    3.While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
    Without multi-information display
    4. Continue to press and hold the button until the trip meter displays “000000”.
    With multi-information display
    4. Continue to press and hold the button until ěMAINT REQD RESET MODE COMPLETE” appears on the multi-information display.
    5. Turn the ignition off and then start the engine to verify the indicator has been reset.