2005-2007
Turn the ignition to run (one position before starting engine).
Push the set/reset button until OIL is displayed on the DIC.
Once OIL is displayed, push and hold the set/reset button for 5 seconds. The number will disappear and be replaced by 100 (indicating 100% oil life remaining).
Turn the ignition off and then start the engine to verify the indicator has been reset.
2000
Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the CHANGE OIL SOON indicator flashes 2 times, the system is reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2001-2005
Turn the ignition to run (one position before starting engine).
Repeatedly push the TRIP/RESET button until OIL is displayed on the DIC.
Push and hold the TRIP/RESET button for 5 seconds. The number will disappear and be replaced by
100 indicating 100 percent oil life remaining.
Turn the ignition off and then start the engine to verify the indicator has been reset.
Reset service light indicator, engine oil life Mercedes Benz Sprinter, year: 2007, oil reset instructions:
Sprinter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles