Tag Archives: negative battery

Reset light airbag fault code Range Rover

How to reset airbag fault code Range Rover.

Reset airbag fault code Range Rover. How to reset the Range Rover Airbag Fault Code warning light. Reset AIRBAG FAULT error message on dash board on a Range Rover.

Instructions:

Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.
Slide the clamp off of the negative battery terminal.
Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.
Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

Reset the Range Rover Airbag Fault Code

Instructions

1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.

2. Slide the clamp off of the negative battery terminal.

3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.

4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

Reset the On-Board Computer for a 2003 Ford Fiesta

Reset service light indicator, engine oil life Ford Fiesta, year 2003 reset instructions:

1. Pull the hood release to open the hood. Prop it up with a rod and locate the battery under the hood.

2. Find the negative battery terminal. You will see a clamp with a nut on it. Loosen the nut with an adjustable wrench and slid the clamp off of the battery terminal.

3. Wrap a towel around the negative battery clamp and keep it away from the battery altogether. The towel will help to protect you and the battery.

4. Let the vehicle sit for about 15 minutes. This will allow the computer to reset and erase all trouble codes.

5. Discard the towel and put the negative battery clamp back onto the negative battery terminal. Tighten the nut with the wrench. Tuck the rod away and lower the hood of the car.

6. Put the key into the ignition and start the engine. Verify that all service and warning lights have turned off.